Navigate to the extracted location and open the “Firmware” folder. Inside you will find a *.dat file.
Create a “\Flash Disk\AutoRun” folder on the CUWIN.
Copy the *.dat file to the AutoRun folder.
Rename the “dat” file extension to “exe”.
Create a file named “UserConfig.ini” with the following contents. Change the BaudRate option to 1, 2, 3, or 4 corresponding to 9600, 19200, 38400, and 115200 respectively.
[Comm]
Baudrate=4
Copy the “UserConfig.ini” file to the CUWIN's “\Flash Disk” folder
On the right side of the CUWIN, locate the 6-position dip switch, and set it to enable “Auto Run” mode.
5000/6000/CWA Series: 1-On, 2-On, the rest Off
CWV Series: 2-On, the rest Off
Reboot the CUWIN it will start in IntelliLCD mode.