comfilehmi:hmi_connection_modport:index
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
comfilehmi:hmi_connection_modport:index [2023/08/11 13:35] COMFILE Technology [DIO Module (digital input/ouput module)] |
comfilehmi:hmi_connection_modport:index [2024/02/01 13:11] (current) COMFILE Technology [Comfile Studio Settings] |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| - | ===== ComfileHMI Editor Settings ===== | + | ===== Comfile Studio Settings ===== |
| When creating a new project, select //COMFILE//, //MODPORT// as shown below. | When creating a new project, select //COMFILE//, //MODPORT// as shown below. | ||
| Line 16: | Line 16: | ||
| {{ :comfilehmi:hmi_connection_modport:comfilehmi_editor_settings_1.png?nolink |}} | {{ :comfilehmi:hmi_connection_modport:comfilehmi_editor_settings_1.png?nolink |}} | ||
| - | * Buad Rate is fixed at 57600,8, N, 1. | + | * Baud Rate is fixed at 57600,8, N, 1. |
| * For models with RS-485 on COM3 (CHA-070WT, CHA-070WR), set the //Channel// to COM3. | * For models with RS-485 on COM3 (CHA-070WT, CHA-070WR), set the //Channel// to COM3. | ||
| * To use MODPORT on models with only COM1, set <line> to COM1 and use a separate RS232-TO-RS485 converter. | * To use MODPORT on models with only COM1, set <line> to COM1 and use a separate RS232-TO-RS485 converter. | ||
comfilehmi/hmi_connection_modport/index.1691728523.txt.gz · Last modified: 2023/08/11 13:35 by COMFILE Technology