Differences

This shows you the differences between two versions of the page.

--- cubloc:set_rs485:index [2026/02/20 15:37] – created - external edit 127.0.0.1
+++ cubloc:set_rs485:index [2026/03/11 02:12] (current) – [Example:] mfranklin
@@ Line 27: / Line 27: @@
 {{ :cubloc:set_rs485:setrs485_2.png?nolink |}}
-The Set RS485 command allows the Cubloc or Cutouch to control the data
+The ''Set RS485'' command allows the CUBLOC or Cutouch to control the data
 line whenever it wants to send or receive data. While the data is being
 sent, the transmit enable pin will output active high. This will be done
-automatically by the Cubloc RTOS.
+automatically by the CUBLOC RTOS.
 *NOTE: If you are using an RS232-to-RS485 converter and it supports
@@ Line 46: / Line 46: @@
 {{ :cubloc:set_rs485:rs485network.png?nolink |}}
-Please refer to the diagram when connectingmultiple Cublocs or Cutouchs using RS485.
+Please refer to the diagram when connecting multiple CUBLOCs or CUTOUCHes using RS485.
-Please use a 120 Ohm terminating resistor for the device at the end.The two 560 Ohm pull-up and pull-down resistors are required for proper communication.
+Please use a 120 Ohm terminating resistor for the device at the end.  The two 560 Ohm pull-up and pull-down resistors are required for proper communication.
 [[cubloc:index#system_library:|Go CUBLOC home]]